Support Center

Slow down the print. This can be done by twisting the knob on the front of Altair counter-clockwise. Raise the temperature of the hot end. T...

  Parts Lifting or Warping Manual Method: Bring hot end down to 1mm above bed. Do a wide sweep with the hot end nozzle by using c...

Just like an aircraft goes through a pre-flight check list before it takes off to make sure that no simple mistakes are made you can do the same ...

If you notice that your prints are twisting slightly there is a very simply fix to this. Sometimes oils or dust can build up on the contact points between t...

Getting filaments to stick to the build layer can sometimes be a tricky. The table below share some tips on how you can get a ...